Traditional reading process

System with passive transponders, have to activate every transponders in order to communicate with systems

Every traditional detection Systems(such as 125 Khz, 134 Mhz etc...) keeps reading transponders while this one is crossing the antenna. This situation creates, when a lot of transponders are present under the antenna at once (Collision), too many data between transponders and reader. It prevents the system from reading 100% transponders.

 

 

 
That’s why traditional systems have to duplicate this process twice or even more.(Several mat lines are necessary to obtain the best detection rate as possible) "There is no intelligence so, there is no control"

(Press Replay on upper window to see the traditional system animation)

Advanced DAG System V6 transponders

(Press Replay on lower window to see the Advanced DAG V6 animation)

When the DAG(transponder)comes into the magnetic field it becomes activated and can communicate with system.

ANTENNA 1: As soon as detection is validated, the advanced DAG V6 is shut down and stop communicate with reader.

This situation creates a lot of space for new DAG which comes into the field. Reader is fully available. This is a much more intelligent system.

Moreover, DAG is so smart that it can keep in memory this command and don’t communicate also on antenna 2

ANTENNA 2: Thus the antenna 2 has just to read the few possible DAG which could have been missed under antenna 1.

The Advanced V6 DAG System intelligence allows a complete control of detection and increase detection rate to 100%